虽然可以收，但还是需要过滤，否则后面消息就会太多了！

Hi! Yes, you can definitely trigger a workflow in n8n from a new message in a Telegram group chat, but there are a couple of important steps to make it work properly.



1、Add your bot to the Telegram group

Just invite your bot like you would add any user.

Make sure to give it admin permissions so it can read messages.

2、Disable privacy mode

Go to @BotFather in Telegram.

Use /mybots → select your bot → Bot Settings → Group Privacy.

Turn privacy mode OFF — this allows the bot to receive all messages in group chats, not just commands.

3、Set up the Telegram Trigger node in n8n

Add the Telegram Trigger node to your workflow.

Set it to listen for the “Message” event.

Use the bot credentials you set up in n8n (Telegram Bot Token).

The trigger will now respond to any message in the group.

4、Filter if needed: If you only want to respond to specific messages or users, you can add a Filter or Switch node after the trigger.